electronic dimmer rs-1-300

The recessed dimmer RS-1-300 is used to switch the fans of your grow room in 3 power levels (Low-Medium-High).

Technical specifications:

• Voltage: 230V, 50/60Hz
• Power tolerated: up to 300W
• Load type: active inductive
• Dimensions: 95x85x60mm
• Degree of protection against dust and humidity: IP40 (front side only)
• Operating conditions: temperature from -10°C to +40°C, humidity up to 80%

Security Requirements:

The installation of the P3 dimmer must be carried out by qualified personnel, in compliance with current regulations. It can be recessed into a vertical wall or in a waterproof box. During the installation procedure it is not allowed:

• ingress of water splashes or raindrops
• exposure to direct sunlight
• installation of heat sources in the immediate vicinity

Installation procedure

Carefully remove the front frame from the potentiometer body Using a screwdriver remove the decorative supports. Connect the switch as shown in the diagram (image 2 / fig. 2) making sure that the connection wires are not connected to the mains and stripping them by 5-7mm. Once connected, fix the potentiometer switch P3 to the wall or in the waterproof box of destination by reassembling the decorative supports and the front frame. The setting of the minimum rotation speed is carried out by adjusting the appropriate setting screw on the back of the potentiometer with a screwdriver. Adjust the speed of the connected aspirator as desired by turning the knob on the front. This power regulator for fans is equipped with an internal replaceable fuse for overload protection. For correct operation, it is recommended to set the minimum speed so that it is not less than half of the maximum speed.

Product guarantee

12 months from the sale subject to compliance with the conditions of transport, storage and installation rules.