Switch dimmer P3

The P3 dimmer, by Vents, is used to switch 3 power levels (Low-Medium-High) the aspirators of your grow room , but also fans and other odor neutralizers.

Specifications:

• Voltage: 230V, 50/60Hz
• Power tolerated: up to 300W
• Load type: active inductive
• Dimensions: 88x88x51mm
• Degree of protection against dust and humidity: IP40 (front side only)
• Operating conditions: temperature from -10°C to +40°C, humidity up to 80%

Security Requirements:

The installation of the P3 dimmer must be carried out by qualified personnel, in compliance with current regulations. This dimmer can be installed on a vertical wall or in a watertight box.During the installation procedure it is not allowed:

• ingress of water splashes or raindrops
• exposure to direct sunlight
• installation of heat sources in the immediate vicinity
• Installation procedure

Using a screwdriver remove the knob on the front. On the back there are 4 ports that fix the front bezel to the switch. Remove the front bezel by pressing the 2 corresponding ports on the back. Connect the switch as shown in the diagram making sure that the connection wires are connected to the mains and stripping them by 5-7mm. Once connected, fix the P3 switch dimmer to the wall or in the destination waterproof box by reassembling the pressure frame (until you hear the click) and the control knob.Position the knob in the OFF position before activating the electrical network, then modulate the speed of the aspirator by turning the knob.

Product guarantee

12 months from sale subject to compliance with the conditions of transport, storage and installation rules.