MW 100 Milwaukee pH meter

The Milwaukee MW 100 pH Meter is a standard portable tester designed for measuring the pH of water and soil. With manual calibration and 0.1 pH resolution, with very low battery consumption, it is a useful device for analysis laboratories, water monitoring and for more demanding growers.

pH tester with MW 100 probe for soil and water

Are you wondering what a pH meter is for? If the pH of the substrate or nutrient solution is too acidic or too basic, this can have a negative impact on the efficiency of the fertilizers. And this results in a possible lack of nutrients for plants.

Newly developed and with an ergonomic design, the pH meter with probe mw 100 is an essential device for every grower . Thanks to this tool you will be able to monitor and keep the acidity values of water and soil under control, ensuring the best conditions for crop growth.

Features of this professional soil and water pH meter include:

1. Large LCD display that facilitates the reading of the results;
2. Quick and easy manual calibration;
3. Up to 1000 hours of battery life in continuous use;
4. Auto shut-off after 8 minutes of inactivity;
5. Effective under the most critical measurement conditions, both in the field and in the laboratory.

What makes the MW 100 the best water pH meter is the provision of an interchangeable probe equipped with a fiber joint, which serves to reduce any possible contamination during the measurement of the fertilizing solutions.

Technical sheet Milwaukee MW 100

• Brand : Milwaukee ;
• Model : MW100;
• Type : Standard portable pH meter;
• Measurement range : 0.0 to 14.0 pH;
• Resolution : 0.1 pH ;
• Degree of accuracy : up to 0.2 pH;
• pH electrode : MA911B/1 (included);
• Temperature compensation : manual, from 0 to 50°C;
• Conditions of use : 0 to 50°C, RH max 95%;
• Battery type : 1 x 9V alkaline (included);
• Dimensions : 145 x 80 x 40mm;
• Weight : 220 g (with battery).

How the pH meter with probe works

Here is a how-to guide to optimal operation of the Milwaukee Probe pH Meter :

1. Insert the battery in the special compartment on the back;
2. Remove the protective cap from the electrode and activate it by immersing it in the maintenance solution (MA9015) for about 2 hours;
3. Connect the pH electrode to the BNC connector on the instrument;
4. Make sure the device has been calibrated before using it;
5. Press the ON/OFF button to start the pH meter;
6. Immerse the tip of the electrode (2.5 cm) in the sample to be measured;
7. Shake and wait for the sample reading to stabilize;
8. After the measurement, switch off the instrument;
9. Rinse and clean the electrode after each use (distilled water is prohibited).

Remember that the electrode must always be kept slightly damp inside the protective cap. For this you can use a few drops of pH7 or pH4.

Buy the MW 100 water pH meter directly online on the Grow Shop Italia website.